Automate AM2 Guía de instalación descargar pdf (Pagina 9)

2003

Directed Electronics, Inc.

Programmer Interface, 3-Pin Port

The BLACK three-pin port is provided for programming of the unit. When using the 998T

Bitwriter

, it is possible to configure any and all of the programmable functions. For more

information please refer to the guide packaged with the programmer.

System Features Learn Routine

The System Features Learn Routine

dictates how the unit operates. It is possible to access and

change any of the feature settings using the integrated LED/Valet

switch. However, this process can

be greatly simplified by using the 998T Bitwriter

. Any of the settings can be changed and then

assigned to a particular transmitter, up to four, a feature called Owner Recognition. Each time that

particular transmitter is used to unlock (disarm) the system, the assigned feature settings will be

recalled. Owner Recognition is only possible when programming the unit via the 998T Bitwriter

If the system was previously programmed using the 998T Bitwriter

, the Learn Routine

may be

locked. If the horn generates one long honk when attempting to program the unit, the Learn

Routine

is locked and must be unlocked using the 998T Bitwriter

before proceeding.

TToo eenntteerr tthhee LLeeaarrnn RRoouuttiinnee

TTMM

KKeeyy..

Turn the ignition on and then back off.

CChhoooossee..

Within 10 seconds, press and release the integrated LED/Valet

switch the number of times corresponding to the feature number you

want to program. (See Feature Menus.) Once the integrated LED/Valet

switch has been pressed and released the desired number of times, press it

once more and hold it. After a second, the LED will flash and the horn

will honk to indicate which feature you have accessed.

TTrraannssmmiitt..

The transmitter is used to select the desired setting. As shipped,

the unit is configured to the LED On settings. These are the default

settings. Pressing the will set it to the LED On setting. The LED will

light solid (stop flashing) to indicate the setting. The horn will honk once

(if connected). Pressing the will change the setting to the LED Off

setting. The LED will go out indicating the change and the horn will

honk twice (if connected).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comentarios a estos manuales

Sin comentarios

Automate AM2 Guía de instalación Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Alarma de carro Automate AM2