Automate AM2 Guía de instalación descargar pdf (Pagina 8)

2003

Directed Electronics, Inc.

Door Lock Harness (H4),

Wire Connection Guide

___

NOTE: For detailed instructions about connecting to the vehicle’s power door lock systems, refer

to the Door Lock Wiring guide (Document No. 1041) available only to authorized dealers though

the www.directechs.com web-site.

Peripheral Plug-In Harnesses

Integrated LED/Valet

®®

Switch, 2-Pin BLUE Plug

The integrated LED/Valet

switch should be accessible from the driver’s seat. It plugs into the BLUE

port on the side of the unit. Consider how the button will be used before choosing a mounting

location. Check for rear clearance before drilling a 9/32-inch hole and mounting the button. The

integrated LED/Valet

switch requires an 1-1/2 inches of rear clearance for mounting.

Super Bright LED, 2-Pin WHITE Plug

The super bright LED part of the integrated LED/Valet

switch operates at (+) 2 volt DC and plugs

into the two-pin WHITE port. Make sure the LED wires are not shorted to ground as the LED will

be damaged.

Integrated

LED/Valet

switch

IMPORTANT! The door lock outputs are low current and should not be attached

directly to any high current device; they are only to be used to activate relays

Blue (-) Unlock, (+) Lock Output

Empty Unless Using 451M

Green (-) Lock, (+) Unlock Output

H2/A

H2/B

H2/C

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sin comentarios

Automate AM2 Guía de instalación Pagina 8