Automate AM2 Guía de instalación descargar pdf (Pagina 7)

2003

Directed Electronics, Inc.

H1/11 RED (+)12V constant power input

Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or

the constant 12V supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the fuse in

the harness for this purpose. This fuse protects the module itself.

H1/12 Red/white channel 2, 200mA (-) output

When the system receives the transmitter code controlling (Channel 2) for longer than 2

seconds, the red/white wire will supply an output as long as the transmission continues. This is often

used to operate a trunk/hatch release or other relay-driven functions.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!

The transistorized output can only supply 200 mA of current. Connecting directly to a

solenoid, motor, or other high-current device will cause it to fail.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sin comentarios

Automate AM2 Guía de instalación Pagina 7